7100 series fire alarm control panel this system must be tested regularly in accordance with the applicable fire codes, consult your fire marshal in case of doubt. normal condition:. do not leave the panel in a trouble condition. the fire alarm may not work properly. lives may be lost in a fire. if the fire alarm system. HONEYWELL COMMON ERROR CODES Comm Failure: System is not communicating due to failure with telephone line Low Bat: System Battery is Low Low Bat + Zone Number: Low battery in wireless receiver Rcvr Jam (or Check 90): RF interference in wireless system Alarm 1xx, Fault 1xx, Check 1xx: Communication failure between control and
Enter Code To End the Fire Drill press then code. Reset Detectors 5VW 6PN 3ZU (QWHU &RGH Enter Code Resets all smoke detector power. Walk Test the System:DON 7HVW (QWHU &RGH. On Alarm or trouble condition has been silenced but condition still exists. AC (green) On Panel is running on AC (normal condition); standby battery fully charged... Description: Troubleshooting: Warning 1: Calibration Overdue: Calibrate the unit. Warning 3: BLE failure (BLE version only) Power-cycle the unit. If this warning occurs again, contact the manufacturer.